Securing The Supervega Evo Suction Unit - Gima SUPERVEGA EVO Manual De Istrucciones

The electrical cable of the bracket has double insulation and it must always be connected to an electrical source (12 V) of the
ambulance. Connection to the power supply source must always comply with the polarity.
In case of incorrect connection, the internal battery cannot be charged.
NOTE: The operations required to fix the bracket are described in the manual (30751/107 - rev.0 dated 23.05.14), which is available to
the installation service of the medical vehicle.
The electrical connections must always be performed by qualified and authorised personnel. Connections must
never be entrusted to unauthorised personnel.
Even if voltage is only 12V

SECURING THE SUPERVEGA EVO SUCTION UNIT

The support bracket has been designed and manufactured only to fix and charge the SUPERVEGA EVO suction unit; no other
device can be secured to this system.
The seal efficiency and charge of the device is guaranteed only for this surgical suction unit model.
Insertion and extraction operations of the suction unit:

Take the SUPERVEGA EVO suction unit;

Place the device on the support bracket pulling the seal hook. Try to fit it inside the section on the bottom of the device;

Before removing your hands from the suction device, make sure that it is fixed correctly (pull the handle of the device
upwards and check the correct position of the device on the bracket);

To remove the suction unit from the bracket, pull the seal hook and remove the suction unit from the section on the bottom
of the device. Firmly hold the device and remove it from the bracket placing it in a safe point.
, short circuit may cause serious damage to persons and objects (risk of fire, etc.).
27
GB