One-Piece Doors - Craftsman 139.53915D Manual Del Propietário

ONE-PIECE DOORS

Please read and comply with the warnings and reinforcement
instructions on the previous page. They apply to one-piece doors
also.
• Center the door bracket on the top of the door, in line with the
header bracket as shown. Mark either the left and right, or the
top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with hardware
supplied.
If the door has no exposed framing, drill 3/16" pilot holes and
fasten the bracket with 5/16"x1-1/2" lag screws (not provided) to
the top of the door.
NOTE: The door bracket may be installed on the top edge of the
door if required for your installation. (Refer to the dotted line
optional placement drawing). Drill 3/16" pilot holes and substitute
5/16"x1-1/2" lag screws (not provided) to fasten the bracket to the
door.
Header Wall
Finished Ceiling
2x4
Header
Bracket
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline
of Garage
Door
Nut 5/16"-18
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.).
(Not Provided)
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" lag screws (Not Provided)
to fasten door bracket.
24
HARDWARE SHOWN ACTUAL SIZE
Lock Washer 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Lock
Washer
Nut
5/16"
5/16"-18
Door Top of Door
Bracket
(Inside Garage)
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
Top Edge
of Door