pro.Bose.com
Front Panel Setup and Configuration
The ControlSpace
SP-24 sound processor has two methods of configuration. The unit may be configured using pre-defined
®
operational modes and loudspeaker Presets from the front panel, or advanced Scenes and configurations may be created using the
SP-24 Editor software. This section addresses the set up and configuration of the unit using the front panel.
For additional information related to the set up and configuration via the SP-24 Editor software, see the SP-24 Editor software
User's Guide available at pro.Bose.com.
Note: The SP-24 Editor software requires the use of a PC running Windows XP or Windows 7 and an available USB port.
The table below outlines the features that can be accessed via the front panel of the sound processor and the ControlSpace SP-24
Editor software.
Load pre-configured mode w/ Bose
Load Custom Scene
Set maximum input level (sensitivity)
Set input gain per channel
Mute input channels
Set input EQ per channel
Select custom channel routing
Set custom bandpass filter per channel
Select per channel Bose loudspeaker EQs
Set 9-band zone EQ per output channel
Set delay per output channel in feet or meters
Set delay per output channel in milliseconds
Set peak limiter per output channel
Set output gain
Mute output channels
Change phase 180 degrees per output channel
Enable User Lockout
Perform a Factory Reset
Open a Scene file stored on a PC
Save a Scene file to a PC
Send a Scene file to the SP-24 sound processor
Recall a Scene file from the SP-24 sound processor to the PC
Update SP-24 sound processor firmware
Input signal and clip indication
Detailed input and output metering
Output signal indication
Assign Bose loudspeakers EQs to individual output channels
Load discontinued Bose loudspeaker EQ
English
Function
®
loudspeaker Preset
Installation and Operating Guide
Using Front Panel
x
x
x
x
x
x
x
x
x
Installation and Operating Guide
Using SP-24 Editor Soft-
ware
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Page 25