Mettler Toledo RPA455 Serie Manual De Instalación página 3

RPA455x / RPA455xx Installation Manual METTLER TOLEDO
© METTLER TOLEDO 2019
No part of this manual may be reproduced or transmitted in any form or by any means,
electronic or mechanical, including photocopying and recording, for any purpose without the
express written permission of METTLER TOLEDO.
U.S. Government Restricted Rights: This documentation is furnished with Restricted Rights.
Copyright 2019 METTLER TOLEDO. This documentation contains proprietary information of
METTLER TOLEDO. It may not be copied in whole or in part without the express written consent
of METTLER TOLEDO.
METTLER TOLEDO reserves the right to make refinements or changes to the product or manual
without notice.
METTLER TOLEDO® is a registered trademark of Mettler-Toledo, LLC. All other brand or product
names are trademarks or registered trademarks of their respective companies.
METTLER TOLEDO RESERVES THE RIGHT TO MAKE REFINEMENTS OR CHANGES WITHOUT
This device complies with Part 15 of the FCC Rules and the Radio Interference Requirements of
the Canadian Department of Communications. Operation is subject to the following conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his or her
expense.
• In 2006, the European Union (EU) Directive on the Restriction of the use of certain Hazardous
Substances (RoHS, 2002/95/EU) went into effect. In 2011, the EU RoHS Directive was
recast (2011/65/EU) and went into effect January 3, 2013. The Directive is to restrict the
use of cadmium, hexavalent chromium, lead, mercury and certain halogenated flame
retardants (PBBs and PBDEs) in electronic products. In 2015, EU RoHS was amended
(2015/863/EU) to restrict four phthalates (DEHP, BBP, DBP, DIBP) by July 22, 2019.
• Based on these inquiries and other procedures, METTLER TOLEDO fulfils its requirements of
RoHS and that our products fully comply with the above mentioned Directive.
30542729
COPYRIGHT
NOTICE.
FCC Notice
RoHS Compliance Statement.
| A | 10/2019
3