Setting The Measuring Arm Limit Stop - KEENCUT ULTIMAT GOLD Manual De Instruccion

4.2
You will
need
3mm
English
CHECK that the matboard has been cut to the correct size. If the Measuring Arm has not given an accurate
measurement then the Measuring Arm Stop finger (X) can be adjusted using a 3mm hexagon wrench.
BEWARE: Some new matboard may not be square.
THE SQUARENESS of the Cutterbar to the End Plate and Measuring Arm is set in the factory before despatch.
However it can easily be adjusted if necessary . Refer to "Squaring Instructions" page (5.1).
Operation

Setting the Measuring Arm Limit Stop

Known width
4.2
(X)