Publicidad
Idiomas disponibles
Idiomas disponibles
Functions
A slot situated on the front side of the receiver and easily opened with a screwdriver, facilitates the access to the
internal dip-switches.
To open the lid, insert the tip of a flat screwdriver into the groove of the hinged lid and lever it up slightly until the snap
happens. Open the lid totally (135°). A light brake maintains the lid in open position. To close the lid, press on the
zone around the groove until the closing snap.
The dip-switches allows to set the functions as described in the following table:
dip-switches
1 and 5
2 and 6
3 and 7
4 and 8
The device does not accept configuration changes during normal operation. A change is taken into account after the
next powering of the device. Therefore, the management and the use of the configuration dip-switches should be
performed with great care.
NB: As shown in the figure and in the previous table, each function is associated with two different dip-switches. The
two different dip-switches associated with a particular function must be configured in the same way.
Configuration at delivery
The device is supplied with the following configuration:
NB: The EDM function can be activated only if the specific input is correctly connected to the appropriate device.
2TLC172294M0201 Rev B
2015-09-17
Dip-switches
Function
-
-
EDM
Reset
EDM deactivated
Automatic Reset
ON
1
2
3
4
5
6
ON
-
-
Deactivated
Automatic
9
7
8
OFF
-
-
Activated
Manual
www.abb.com/jokabsafety
Publicidad
