AllPondSolutions AUTO-PFC-5000 Manual De Instrucciones página 11

Deep Clean Maintenance
All internal cleaning should be done using pond water only. This is to ensure the
living bacteria within your filter is not affected. Using tap water will kill all living
bacteria within your pond filter so it is vital that only pond water is used when
doing cleaning maintenance.
Remove the filter lid - Unfasten the Head Clasp (part 17/20) and remove.
Pull the AUTO-PFC Lid (part 8/9) clear of the filter and place upside down
on a flat surface.
Remove the filter sponges -
Unscrew parts AUTO-PFC-5000
20, 21, 16, 22, AUTO-PFC-50000 14
15, 16, then remove the filter
sponges.
Clean filter sponges - Clean the
filter sponges and replace.
Re-attach the parts as above.
Clean bio-mechanical media -
rinse through your filter media.
Clean body and all attachments.
Reassemble.
O-rings
It is vital that O-rings are regularly inspected and replaced as the rubber
watertight seal will perish over time, which may cause your unit to leak. Before
replacing your o-rings, ensure they are well lubricated.