Getting Started; Turn Speaker On/Off; Add Bluetooth Device; Play Music From External Source - IKEA ENEBY Manual De Instrucciones

Getting started:

1. Connect mains cord into AC In (2)
connector.
2. A quick press on the knob (1) turns the
speaker on/off. White LED is now on.
If a paired device is found, the LED
shines without blinking and your speaker
is ready to use.
3. If no device is found the speaker LED
continues to blink and enters pairing
mode automatically. Go to the Bluetooth
settings in your mobile device and
connect to ENEBY 20/30. The LED should
now stop blinking and your speaker is
ready to use.
If no music has been playing for 20min,
the speaker will enter sleep mode.
Adjust Volume
Turn the knob (1) left to decrease or turn it
right to increase volume level.
Add additional Bluetooth device(s)
(max 8 devices)
1. Go to your Bluetooth menu on your
mobile device and connect to ENEBY
20/30.
2. Once Bluetooth connection is
established, the white LED stops
blinking.

Other settings:

Bass Control:
Treble Control:
Factory reset::
Press knob (1) 3 sec. This enters the bass level control.
LED flash slowly. Turn left/right to adjust. Confirm bass setting and
enter the treble setting control by pressing the knob one time.
LED flash quickly. Turn left/right to adjust treble and confirm by
pressing the knob one time and exit sound settings.
Press knob (1) 10 sec. This deletes all paired Bluetooth devices and
restores default sound settings.
Unpair Bluetooth device
Go to your Bluetooth menu on your mobile
device and unpair ENEBY 20/30 from your
devices.

Play music from external source:

Connect a portable audio device to the
AUDIO IN (3) jack on the rear panel. The
speaker automatically detects the external
input and disables Bluetooth functionality.
Use a 3.5mm 3-pol Audio cable for this
feature.

Use speaker throughout home:

ENEBY 20 has the possibility to be portable.
ENEBY battery pack is sold separately.
— To insert the battery, open the
compartment lid (5) and insert the
battery in the correct direction.
— The battery is charged in the product
when mains cord is connected.
— When battery is low a red LED in the
knob (1) will flash. During charging the
red LED is on.

Attach Speaker to a wall or a stand:

ENEBY wall mount and ENEBY stand are
accessories and are sold separately.
Use holes (4) and included screws to mount
stand or wall mount. Do not over tighten
the screws.
5