Battery Operation; Radio Operation - lauson CP451 Manual De Usuario

to operate the radio on any other power source. You could cause damage to the unit and void
your warranty.
A. BATTERY OPERATION
1. Remove the Battery Door.
2. Install 6 x DC1.5V "C" (UM-2) batteries (not included) according to the polarity diagram
inside the battery compartment.
IMPORTANT: Be sure that the batteries are installed correctly. Wrong polarity may
damage the unit.
BATTERY NOTE AND CARE
1. Danger of explosion if the battery is replaced incorrectly. Replace only with the same or
equivalent type
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
4. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking
batteries can cause damage to the unit and may void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer's directions).
6. Do not dispose of batteries in fire, batteries may leak or explode.
BATTERY REPLACEMENT
When the output sound of this unit becomes distorted or the CD player operation appears
unstable, the batteries are weak. You need to replace all the exhausted batteries at the same
time as soon as possible to avoid battery leakage.
B. AC OPERATION
Plug the detachable AC cord into a standard AC outlet (230V~50Hz).
1. When the AC power cord (included) is connected to the AC Power Socket on the back of
the unit and the other end is plugged into a 230V AC~ 50Hz wall outlet, the unit will
disconnect the batteries automatically, and operate on AC Power only.
2. Slide the FUNCTION SWITCH to "CD/AUX/USB/BT" for AUX or CD play, "FM" for FM radio,
"AM" for AM radio and "OFF" for unit power off.
Slide the FUNCTION SWITCH to "FM" or "AM" as desired, the POWER Indicator will light.
1.
2. Rotate the TUNING CONTROL KNOB to your desired radio station according to the DIAL
SCALE on the knob.
3. Rotate the VOLUME CONTROL KNOB to adjust to the desired output level.
To turn off the radio, slide the FUNCTION SWITCH to "OFF" position. The POWER
4.
Indicator will go off.
Please Note: LED light show may interfere with the AM radio reception. If you experience weak or
noisy AM reception when the LED light show is ON, please turn off the LED light
show by sliding the LIGHT switch to OFF position.
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change
the position of unit until the internal antenna picks up the strongest signal.
FM – If a stereo broadcast program is being received, the FM STEREO INDICATOR will light.
During FM or FM Stereo reception, always keep the FM TELESCOPIC ANTENNA fully

RADIO OPERATION

4
EN