lauson CP451 Manual De Usuario página 5

extended for best performance. However, if FM reception is weak, try repositioning the
unit near an open window until you get the best reception.
PLEASE READ THIS IMPORTANT INFORMATION:
If playback does not start, it is likely due to the quality of the CD-R/RW disc and/or the compatibility
of the CD compilation software. The manufacturer is not responsible for the playback quality of CD-
R/RW discs. Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
DISC PLAY MODE
Slide the FUNCTION SWITCH to the "CD/AUX/USB/BT" position. The LCD DISPLAY will
1.
light.
2. Open the CD DOOR, load a CD with the label side facing upward and then close the CD
door. A few seconds later the total number of tracks on the CD will appear on the LCD display.
3. Press the PLAY/PAUSE
PLAY/PAUSE Indicator will light steadily.
4. While playing, press the
Press the BUTTON again to resume playing.
5. Adjust the VOLUME CONTROL to the desired volume level.
Press STOP ■ BUTTON to stop playing.
6.
7. To turn off the CD player, slide the FUNCTION SWITCH to "OFF" position. The LCD
DISPLAY and Power Indicator will go off.
NOTE: If skipping occurs during CD play, try turning the volume down. Do not open the CD
DOOR when a CD is playing.
REPEAT MODE
1, Press the "MODE" button one time during playback or pause mode,
flashing, the current single track can be repeated.
2, CD disc playing, press the "MODE" button two times during playback or pause mode,
displayed, the current all tracks can be repeated
3, MP3 playing, press the "MODE" button two times during playback or pause mode,
displayed, the current folder can be repeated
4, Press the "MODE" button three times during playback or pause mode,
flashing, all tracks can be repeated.
4, Press the "MODE" button four times during playback or pause mode,
repeating cancelled.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the SKIP/Search Forward
BUTTON to go to the next track or go back to the beginning of the current track.
2. During Play mode or Pause mode, press and hold the
the current track with audible high speed playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Press the "MODE" button short time during stop mode , LCD display will show P01 and flash.
2. Press the SKIP/Search Forward
track to be programmed.
3. Press the "MODE" button again to store the selection. The Program Number will advance
CD OPERATION
BUTTON to start playing the CD from the first track. The
BUTTON once to pause, the PLAY/PAUSE Indicator will flash.
or SKIP/Search Backward
is displayed with
is displayed without
is displayed,
or SKIP/Search Backward
or BUTTON to search within
BUTTON to select the
is
is
5
EN