Finishing The Installation - Progress Lighting AirPro P250040 Manual De Instalación

Finishing the Installation

Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 10)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger ball
before attaching the canopy to the bracket by
turning the housing until it drops into place.
Outlet box
Hanger
bracket
Figure 10
Attaching the Blade Holders
Step 1. Insert the blade holder through the slot in
the housing. Align the holes in the blade and the
fan motor assembly and secure with the blade
holder attachment screws (1/4"x22mm) with lock
Screws
washers. (Fig. 11)
Step 2. Repeat this procedure with the remaining
Canopy
blade holders.
Canopy cover
Screws (1/4"x22mm)
with lock washers
Figure 11
Blade holders
6.