Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Control
It replicates the function of the Standby button on the top panel
1. Power button
It replicates the function of the same button located on the top panel
2. LED
It glows every time the remote is used
3. Indicator light
Cancels the audio coming from the speaker. Press it again to unmute the
4. Mute button
speaker
Increases or decreases the treble (high) frequencies at a range between -6dB
5. TREBLE
to +6dB
It replicates the function of the same button located on the top panel
6. BASS
Press these butons to increase or decrease the output volume of the speaker
7. VOL+/VOL-
It replicates the function of the same button located on the top panel
8.
It replicates the function of the same buttons located on the top panel
9.
/
Press any of these buttons to select the corresponding input mode
10. Aux, BT and USB
Briefly press this button to reset the speaker to factory default values
11. Reset
Scanning, channel selection, tuning and storage of favorite frequencies
12. Tuner
In USB mode, press any key from 0 to 9 on the remote to choose directly the
tracks you want to play
13. Numbered keypad
In tuner mode, it allows the manual input of frequencies
IV. Initial setup
Powering on the unit
1. Turn the main volume, echo and mic volume controls on the top panel fully counterclockwise.
2. Insert the power cable in the AC jack on the back of the unit, and plug the other end into a standard wall
outlet.
3. Turn the power switch to the on position.
V. Advanced operation
Pairing the speaker with wireless devices
Note: Before installing this product, please make sure your device has the built-in Bluetooth
1.
Start by pressing the ST-BY button once on the top panel to activate the speaker functions.
2.
Next, enable the Bluetooth
feature on your audio device and set it to discover the wireless speaker.
®
3.
Remember to place your wireless device and the speaker not more than one meter away from each other.
4.
Select the Bluetooth
feature on the speaker by pressing the BT button found on the media panel. A tone
®
will be heard, while the bt symbol appears on the display with the dot blinking to indicate that the speaker
has entered into the pairing mode.
5.
Once the speaker appears listed under the newly found Bluetooth
device, it will ask if you want to pair with it.
6.
Accept by pressing Yes or Ok. If you have a lower Bluetooth
passkey 0000 (4 zeros).
7.
When pairing is successful, the dot next to the bt symbol will stop blinking and appear steady on the display.
If after 60 seconds the pairing process fails, please repeat steps 1 through 6 described above.
8.
You can now start streaming audio through the speaker wirelessly from your favorite Bluetooth
devices.
9.
Pres and hold the
for 3 seconds in order to put the speaker back into pairing mode.
Description
feature available.
®
devices (KWS-920) of your wireless
®
version, you may be prompted to enter the
®
-enabled
®
Using the wireless microphones
1.
Insert AA batteries into the handheld microphones by carefully unscrewing the base of each one and
aligning the "+" and "-" terminals of the batteries with the corresponding contacts inside the compartment.
2.
With the Mic. volume 1 and 2 controls turned down, switch on each wireless microphone in turn . The
LED screen on each unit will become illuminated.
3.
Gradually increase the volume and echo controls, testing each microphone output through the speaker. As
you increase the volume, make sure not to stand too close to the speaker to avoid loud feedback.
4.
When not in use, switch the wireless microphones off to conserve battery power.
Publicidad
Tabla de contenido
