Advanced Planning; Before You Begin - Thermador PH30HWS Manual De Instrucciones

Advanced Planning

Before You Begin

CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
Parts included
• Metal transition with backdraft damper
• Stainless steel baffle filters
• Stainless steel grease trays
• Stainless steel filter spacers
• Heat lamps (on PHxxGWS models)
• Blower adapter
• Wood support bracket used as hood mounting
bracket (part of install- DO NOT THROW AWAY)
• Fastener assortment*
* Hardware provided is for mounting through standard
thickness drywall or plaster into wood studs. Installers are
responsible to provide hardware for other types of
mounting situations.
Tools and Parts Needed
• Blower (refer to the Ventilation Planning Guide for
compatible blowers)
• Ducting as needed (refer to Equivalent Duct Lengths
for Commonly Used Transitions Table)
• Aluminum tape (DO NOT use duct tape.)
• 1/2'' (13 mm) Conduit if required (follow local codes)
• 1'' (25.4 mm) Strain relief
• Phillips screwdriver
• T-20 Torx head screwdriver
• Drill with 3/16'' (4.76 mm) drill bit
• 11/32'' nut driver or socket and ratchet
• Circular saw or jigsaw
• Tape measure
• Protective work gloves
IMPORTANT: DO NOT throw away any packaging until
appliance is fully installed.
Page. 6
Optional accessories available for
separate purchase
Refer to www.thermador.com for more details.
• DC***W – 6 in. tall Duct Cover
• DC**TW – 20 in. – 54 in. Telescoping Duct Cover
• REMCPW – Remote Control Panel
• EXTNCB25W – 25 ft. Remote and Inline Blower
Extension Cable
• WC8 - 8" Wall Cap
• WC10 - 10" Wall Cap
• RFPLT600P - Roof plate for use with 600 CFM Remote
Blower VTR630
• RFPLT1000P - For use with 1000 CFM Remote Blower
VTR1030 and 1300 CFM Blower VTR1330