Annual Maintenance; Troubleshooting; Fluid - SmartWasher SW-45 Manual De Operación

ANNUAL
MAINTENANCE
ChemFree Corporation recommends that the SmartWasher be
inspected and cleaned annually.
To Perform this Maintenance:
Do this by simply pumping out the fluid into containers until the
machine is drained. Unplug the SmartWasher. Remove the
sink from the base and inspect the bottom of the unit for any
sludge that might have accumulated at the bottom. Clean the
base with water to remove any debris. Visually check the condi-
tion of the hoses, connectors, etc. If everything appears to be in
good working condition, reassemble sink, change OzzyMat, and
return the OzzyJuice to the SmartWasher.
If you fail to maintain your SmartWasher, you may still be
able to save your fluid. Simply perform the annual maintenance
described above and then add OzzyBooster for an extra supply
of microbes to bring your fluid back into conformity. If your fluid
had developed an odor, you may also add Odor Neutralizer.

Fluid

Troubleshooting

INADEQUATE CLEANING OF PARTS
The SmartWasher will continue to clean parts even when the
fluid color has darkened and the OzzyMat is soiled. If, however,
a dramatic change in cleaning performance is noticed, it is rec-
ommended that the old fluid be replaced with fresh OzzyJuice
and that the OzzyMat be replaced. If the cleaning performance
continues to remain unacceptable, call ChemFree Technical
Support.
COLD FLUID
The thermostat is factory-set to maintain the fluid at 108° F(+-2°)
(42°C)(+-1°). IF THE SMARTWASHER IS LOW ON FLUID,
THE HEATER AUTOMATICALLY SHUTS OFF. Check to see if
the "Add Fluid" indicators are lit (there should be approximately
8 inches {20 cm.} of fluid in the machine). If the "Add Fluid"
lights are lit, add a full container of OzzyJuice (the lights should
go out). Allow approximately 4 hours for the fluid to warm up
and recheck. If the fluid is still cold refer to Troubleshooting
Guide on page 5.
OVERHEATED FLUID
If the fluid becomes extremely hot and exceeds 120°F (49°C)
unplug the SmartWasher and have probe replaced.
LOW OR NO FLUID FLOW FROM BRUSH
AND/OR NOZZLE
ChemFree Technical Support 1-800-521-7182 x2624
www.ChemFree.com
Check the following for problems:
1. Make sure that the valves at the base of the nozzle and
brush are open. If a stronger flow through either device is
needed, turn the valve on the unused tool to the closed
position.
2. Hoses from the pump to the nozzle and brush could be
clogged, pinched or disconnected. Check the hoses from
the pump to the nozzle making sure they are in working
order.
3. Hose connections should be secure and not leaking.
4. Make sure SmartWasher is not low on fluid.
5. The pump could be malfunctioning. (Refer to the
Troubleshooting Guide on page 5). The pump comes with a
one year factory warranty. If the pump is faulty, call your
local distributor or ChemFree technical support to order
your warranty replacement. Have the serial number of the
SmartWasher unit available when calling.
3