Cost Rate; Clock And Calendar - Oregon Scientific ESM200 Manual Del Usuario

* Alternative method to change units:
1. While in normal display, press MODE repeatedly to enter
GREENHOUSE GAS display.
2. Press and hold ADJ��T repeatedly to change
measurement unit.
CO�T RATE
To determine the approximate cost of electricity consumption,
input the cost per KWh.
This unit allows the input of up to 4 different cost rates (Tariff)
to accommodate the different rates local utility companies
may charge consumers depending on the hour electricity is
consumed.
The icon will be displayed to remind users that
electricity used during that period will be charged at peak
rates.
There is also a built-in alarm to alert users when the
electricity cost per hour exceeds a pre-set limit.
By raising awareness of consumption behaviour, better
consumption habits may be adopted which will in turn reduce
the cost of electricity bills and impact on the environment.
To set cost rate:
. Press and hold �ET to enter Setting mode.
2. Press MODE repeatedly to navigate to sub setting
COST. Press �ET to enter.
3. Press �ET to enter TAR  setting.
4. Press �ET to enter TIME setting.
5. Press ADJ��T to change setting values.
6. Press �ET to confirm and move to next setting. The
setting options are hour, minutes, rate, peak (yes / no)
and alarm (on /off).
NOTE
If there is only one electricity rate for the entire
duration of the day, select OFF for TAR 2-4.
for other TAR �-4 settings:
. Press �ET to enter TAR 2 setting.
2. Press ADJ��T to select ON.
3. Repeat steps 4-6 above.
To exit �etting mode:
. Press MODE repeatedly to navigate to END.
2. Press �ET to exit and return to COST display.
If originally on upper line of display, repeat steps 1-2 to exit
completely.
Alternative method to enable ��disable alarm:
• Press and hold MODE (when not in setting mode).

CLOCk AND CALENDAR

. Press and hold �ET to enter Setting mode.
2. Press MODE repeatedly to navigate to sub setting TIME.
Press �ET to enter.
3. Press ADJ��T to change setting values.
4. Press �ET to confirm and move to next setting.
The setting options are hour format, hour, minutes.
5. Press �ET to enter DATE menu options.
6. Press ADJ��T to change setting values.
7. Press �ET to confirm and move to next setting.
The setting options are date format, year, month, day.
8. Press MODE repeatedly to navigate to END. Press �ET
to exit and return to COST display.
0