Assembly And Installation 4.ASsembly And Installation 9 - ITC FERTIC Manual Original

4.ASSEMBLY AND INSTALLATION 4.ASSEMBLY AND INSTALLATION
GB GB
The special supports of stainless steel (66230) permit the installation of The special supports of stainless steel (66230) permit the installation of
the pump on the floor, or a flat surface, or on the wall. the pump on the floor, or a flat surface, or on the wall.
The FERTIC pump should always be installed in the position indicated in the The FERTIC pump should always be installed in the position indicated in the
diagram so that the axes of the fertilizer connections are in a vertical position diagram so that the axes of the fertilizer connections are in a vertical position
with the regulation turret above. with the regulation turret above.
The nuts M-6 (66334) necessary for the installation are furnished together with The nuts M-6 (66334) necessary for the installation are furnished together with
the supports. In the wall assembly, six nuts are needed, on the floor, eight. the supports. In the wall assembly, six nuts are needed, on the floor, eight.
Put two inlets (A) and (B) in the water network where the pump is going to be Put two inlets (A) and (B) in the water network where the pump is going to be
located at a minimum distance of 0.25 m. (0.75 ft) from each other. located at a minimum distance of 0.25 m. (0.75 ft) from each other.
Pressure inlet (C) Connect the flexible pressure inlet hose (A) to the pump Pressure inlet (C) Connect the flexible pressure inlet hose (A) to the pump
Fertilizer injection(F) From the pump connector (F) put the flexible Fertilizer injection(F) From the pump connector (F) put the flexible
Fertilizer suction (E) Place the 70 mesh filter Do not suck up the fertilizer Fertilizer suction (E) Place the 70 mesh filter Do not suck up the fertilizer
Drainage (D) Connect the free drainage hose to the outside or to the suction of Drainage (D) Connect the free drainage hose to the outside or to the suction of
IMPORTANT IMPORTANT
It is advisable to put plastic ball valves at the water inlet (A) fertilizer injection It is advisable to put plastic ball valves at the water inlet (A) fertilizer injection
(B) and fertilizer suction (E) for the maintenance of the pump. (B) and fertilizer suction (E) for the maintenance of the pump.
Fertilizer should not be sucked from de tank bottom to avoid taking up non Fertilizer should not be sucked from de tank bottom to avoid taking up non
dissolute particles. dissolute particles.
connector (C) inserting the 70 mesh line filter that is connector (C) inserting the 70 mesh line filter that is
provided. provided.
injection hose at the irrigation network inlet (B) inserting injection hose at the irrigation network inlet (B) inserting
the antisyphon valve at a minimum of 0.5 m. (1.5 ft) the antisyphon valve at a minimum of 0.5 m. (1.5 ft)
above the fertilizer level. above the fertilizer level.
directly from the tank bottom. directly from the tank bottom.
the irrigation pump. the irrigation pump.
D D
C C
F F
E E
9 9