Sears Craftsman 320.10870 Manual Del Usuario página 26

POSITIVE 0 ° BEVEL STOP
Your saw has a positive 0 ° bevel stop and it was adjusted at the factory to assure
0° angle of the saw blade for 90o cuts,. However, shipping can cause misafignment.
HOW TO CORRECT THE 0 ° ANGLE SE'rrlNG (Flgo 17 and 17a)
1. Unplug the saw°
/_ WARNING:
At.WAYS unplug saw before making any adjustments. Failure
to unplug the saw could result in accidental starting which can cause serious
personal injury.
Fig, 17
Carpenter's E uare
Pointer
Bevel Adjustment locking tever
Saw blade
2. Place saw in an upside down position on workbench_
3, Use a carpenter's square to check the squareness of the saw blade to the base of your saw.
4. If saw is not square, loosen
bevel adjustment lever
(see Fig17)
Fig. 17a
5, Locate the slot (see Fig.17a)
on the bottom of the base
that has a hex adjusting
screw, Adjust this screw
up or down with a 3ram
Allen wrench or Hex
Key (3/32-in.) until
blade is square
to base.
6. Tighten bevel
adjustment lever.
26
L ....