Safety Rules For Circular Saws - Sears Craftsman 320.10870 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY RULES FOR CIRCULAR SAWS
Keep hands away from cutting area and blade. Keep your
second hand on the auxiliary handle or motor housing. If both hands are holding
the saw, the blade cannot cut them.
I_
CAUTION:
Blades coast after saw Is switched off.
1 KEEP your body positioned to either side of the saw blade and not in direct
line with the saw blade° Kickback could cause the saw to jump backwards_ (See
"Kickback .,What Causes It and Ways to Prevent It" on pages 16 and !7).
2, DO NOT reach underneath
the work. The guard cannot protect you from the blade
beneath the workpiece,
_
When sawing through a workpiece, the lower blade guard
DOES NOT cover the blade on the underside of the workpiece (Pg. 15 Fig, 2),
ALWAYS keep your hands and fingers away from the cutting area.
3 CHECK lower guard for proper closing BEFORE each use° DO NOT operate the saw
if the lower guard does not move freely and close instantly. Never clamp or tie the
lower guard In the open position.
If the saw is accidentally dropped, the lower guard may
be bent. Raise the lower guard with the retracting lever The guard is operating properly
when it moves freely, does not touch the blade or any other part in all angles and depths
of cut, and readily returns to the closed position.
4. CHECK the operation
and condition of the lower guard spring. If the guard and the
spring are not operating
properly, they MUST BE serviced before use. The lower
guard may operate sluggishly, due to damaged parts, gummy deposits, or a buildup of
debris, DO NOT operate your saw until the damage has been repaired or replaced
5. The lower guard should be retracted manually ONLY for making special cuts, such
as pocket or compound cuts, ALWAYS raise the lower guard by retracting
Its lever,
As soon as the blade enters the material, the lower guard MUST be released. For all
other sawing, the fower guard should operate automatically.
6. ALWAYS make sure that the lower guard is covering the blade BEFORE placing the
saw down on a work bench or floor, An unprotected moving blade will cause the saw to
walk backwards, cutting whatever is in its path. Make note of the time it takes for the blade
to stop spinning after the switch is released.
7o NEVER hold the piece being cut in your hands or across your legs. It is importantto
support the workpiece properly in order to minimize body exposure, blade binding, or loss
of control.
8, HOLD TOOL by insulated gripping surfaces (handles) when performing
an operation
where the cutting tool may contact hidden wiring or its own cord. Contact with a "live"
wire will make the exposed metal parts of the tool "live" and shock the operator
9. ALWAYS clamp the workpiece securely so it wiil not move when making the cut.
10oWhen ripping, ALWAYS USE a rip fence or straight edge guide, This improves the
accuracy of the cut and reduces the chance of the blade binding°
11 ALWAYS USE blades that have the correct size and shape (diamond vs. round) arbor
holes. Blades that do not match the mounting hardware of the saw will run erratically and
cause loss of control
9

Publicidad

Tabla de contenido
loading

Tabla de contenido