Ordering Replacement Parts - EINHELL DKS 405 Manual De Instrucciones

Anleitung DKS 405
7.3 Tilting the saw table (Fig. 6)
Undo the locking screw (12).
Tilt the table (14) to the left until the indicator (11)
points to the required angle value on the scale
(13).
Important: For precision work you should first
carry out a trial cut and then re-adjust the tilt
angle as required.
8. Operation
8.1 Please note:
Your saw does not cut wood automatically. For
cutting to occur, you have to guide the wood
against the blade.
The teeth cut only on the down stroke of the
blade.
You have to guide the wood slowly against the
blade because the teeth are very small.
Every new user needs a certain training period.
You are certain to break a number of blades at
the beginning.
When cutting thick timber, be particularly careful
not to bend or twist the blade. This will help to
prolong blade life.
8.2 Switching the saw on and off
Press the green button to switch the saw on.
Press the red button to switch the machine off.
Please note: The machine is equipped with a
safety switch to prevent it being switched on
again accidentally after a power failure.
8.3 Carrying out internal cuts
1. A feature of this fretsaw is that it allows you to
carry out internal cuts in a panel without
damaging it on the outside or circumference.
WARNING: TO PREVENT INJURIES DUE TO THE
SAW STARTING UP ACCIDENTALLY, ALWAYS
SET THE SWITCH TO „0" POSITION AND PULL
THE POWER PLUG OUT OF THE SOCKET-
OUTLET BEFORE YOU REMOVE OR CHANGE
THE BLADE.
06.11.2001 11:26 Uhr Seite 13
2. To carry out internal cuts in a panel: Remove the
blade as described in Section 7.2
3. Drill a 6.3 mm hole in the panel.
4. Place the panel on the saw table with the drilled
hole above the access hole.
5. Install the blade through the hole in the panel and
adjust the blade tension.
6. When you have completed the internal cuts,
remove the blade from the blade holders (as
described in Section 7.2) and take the panel off
the table.
9. Maintenance
Bearings
Lubricate the bearings of the guide rollers
periodically with high-grade machine grease, but at
least after every 25-30 hours in operation.
Cleaning
Sawdust should be removed from the inside of the
fretsaw at regular intervals. Switch off the machine
and pull out the power plug before you open the left
cover (6). You can then use a brush or vacuum
cleaner to clean the inside. Sawdust and chips have
to be removed from the motor's air vents after every
work session.
Maintenance
Do not carry out any repairs yourself. If any problems
arise, take your fretsaw to a specialist workshop.

10. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
GB
13