Craftsman 351.211930 Manual De Usuario página 3

o Use recommended accessories (refer to page 9). Use of
improper accessories may cause risk of injury to persons..
,, Do not overtighten wheel nut. Replace cracked wheel
immediately. Use only flanges supplied with the grinder
o Adjust distance between wheel and tool rest to maintain
'/,_" or less gap..
° Handle the workpiece correctly Whenever possible, use
tool rest to support workpiece during grinding operation.
Turn tool off if it jams=
,, Always use guards and eyeshields_
,, Clean grinding dust from beneath tool frequently.
CAUTION:
Think safety] Safety is a combination of operator
common sense and alertness at all times when tool is being
used..
WARNING: Do not attempt to operate tool until it is com-
pletely assembled according to the instructions°
Refer to Figures 1, 2 and 3, pages 3 and 4.
Check for shipping damage., tf damage has occurred, a claim
must be filled with carrier. Check for completeness.
Immediately report missing parts to dealer
The grinder comes assembled as one uniL
Two extra wheels are included:
• 8" Grinding wheel 36 grit (course)
• 8" Grinding wheel 60 grit (medium)
Parts for stand and additional parts which need to be fas-
tened to grinder, should be located and accounted for before
assembling
To be certain the grinding wheels have not been damaged in
shipping, strike the edges slightly with a metal object.. A ring-
ing sound indfcates a good wheel, but a dull noise may signal
a fracture
WARNING: If you suspect a wheel of being fractured,
replace it immediately Fractured wheels may shatter, causing
serious injury
STAND
Parts to be assembled should be located and accounted for
(See List and Figure 1)
A Foot pad, 4 each
B Leg section, 8 each
C Short brace, 2 each
D _f_-18 x _" Carriage bolt, 24 each
E _,_" Flat washer, 24 each
F _/.,"=18 Hex nut, 24 each
G Long brace, 2 each
H Top, 1 each
1 8-1..25 x 45ram Hex bolt, 4 each (not shown)
J 8mm Flat washer, 8 each (not shown)
K 8ram Lock washer, 4 each (not shown)
L 8-1..25mm Hex nut, 4 each (not shown)
F
Figure 1 - Stand
EYESHIELD
Parts to be assembled should be located and accounted for
(See List and Figure 2).,
A 8ram Serrated washer, 2 each
B #I0-24 x ¾" Pan head screw, 4 each
C Upper eyeshie]d bracket, 2 each, (left and right)
D Lower eyeshield bracket, 2 each
E Eyeshield, 2 each
F 6mm Fiat washer, 2 each
G Knob, 2 each
H ¼" Flat washer, 2 each
I ¼" Lock washer, 2 each
J '/,-20 x ¾" Hex bolt, 2 each
K Spark guard, 2 each (left and right)
C D
B
'
Figure 2 - Eyeshleld Assembly