Maytag P6WB2L Manual Del Usaurio página 28

Water is leaking or dripping The glass was not held under the Hold the glass under the dispenser 2 to 3 seconds after
from the dispenser system dispenser long enough, releasing the dispenser lever.
NOTE: A few drops of water
after dispensing is normal.
Water continues to drip The refrigerator has just been Flushing the water system removes the air from the lines
from the dispenser beyond installed, which causes the water dispenser to drip. Flush the water
the first few drops, system. See "Water and Ice Dispensers."
The water filter was recently installed Flushing the water system removes the air from the lines
or replaced, which causes the water dispenser to drip. Flush the water
system. See "Water and Ice Dispensers."
Water is leaking from the The water line connections were not See "Connecting the Water."
back of the refrigerator fully tightened.
Recently removed the doors and did See "Refrigerator Doors and Drawer."
not fully tighten water line connection
Water from the dispenser is Water from the dispenser is chilled to This is normal.
warm 50°F (10°C).
The refrigerator has just been Allow 24 hours after installation for the water supply to cool
installed, completely.
A large amount of water was recently Allow 3 hours for the water supply to cool completely.
dispensed.
Water has not been recently The first glass of water may not be cool. Discard the first
dispensed, glass of water dispensed.
The refrigerator is not connected to a Make sure the refrigerator is connected to a cold water pipe.
cold water pipe. See "Water Supply Requirements."
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for "door closing and door alignment."
The doors will not close
completely
The doors are difficultto
open
The doors appearto be
uneven
The door is blocked open. Move food packages away from door.
A bin or shelf is in the way. Push bin or shelf back into the correct position.
Recently installed Remove all packaging materials.
The door gaskets are dirty or sticky. Clean gaskets and contact surfaces with mild soap and
warm water. Rinse and dry with soft cloth.
The doors need to be aligned, or the See "Refrigerator Leveling, Door Closing and Alignment."
refrigerator needs to be leveled.
The refrigerator is unsteady The refrigerator brake feet are not Remove the base grille. Turn both brake feet (one on each
or it rolls forward when snug against the floor, side) clockwise, the same amount, until they are snug against
opening and closing doors the floor. See "Refrigerator Leveling, Door Closing and
Alignment."
28