How To Replace The Doors And Hinges - Maytag MBB1952GRQ Guía Del Usario

FREEZER HANDLES
Installing Partial-Width Handle
Install handle by
fastening with screws
removed from edge
of door.
• If reversing freezer door, remove
door plugs from top edge of door and
insert into screw holes.
Removing Partial-Width Handle
Remove handle by
removing screws
from top of handle.
• Retain screws for
later replacement.
Installing Full-Width Extruded Handle
Install handle by fas-
tening with screws*
removed from edge of
door.
Removing Full-Width Extruded
Handle
Remove handle by
removing three
screws* from handle.
• Retain screws for later replacement.
* Fasteners may require either a T-15 Torx
Torx ® is a registered trademark of Textron Inc.
How to replace the
doors and hinges
1. Install hinge assemblies.
• Install top hinge loosely with
head screws.
• Install center hinge with Phillips
screws.
• Install bottom hinge with
screws.
2. Insert bottom hinge pin
(select models).
• Locate bottom hinge
hole closest to out-
side edge of cabinet, and insert bot-
tom hinge pin. Replace any door
shims, if present.
3. For freezer door
models only: Place
hinge side of freezer
door on bottom hinge
pin and hold freezer door upright while
installing center hinge pin with
head driver.
• Replace any applicable door shims.
• Make sure the hinge pin is installed
tightly.
® driver or a Phillips screwdriver.
For freezer drawer models only:
Install center hinge pin with a
head driver.
• Replace any applicable door shims.
• Make sure the hinge pin is installed
5 " hex
⁄
tightly.
16
4. Place hinge side of refrigerator door
on center hinge pin.
5. While holding refrigerator
3 " hex head
⁄
door upright,
8
down top hinge with
hex head driver and
replace hinge cover.
" hex
5
⁄
16
5 " hex
⁄
16
tighten
5 "
⁄
16
4