Engine Lubrication; Air Cleaner - Craftsman 917.297031 El Manual Del Propietario

_CAUTION: Disconnect spark plug
wire before performing any maintenance
(except carburetor adjustment) to prevent
accidental starting of engine,
Prevent fires! Keep the engine free of
grass, leaves, spilled oil, or fue!. Remove
fuel from tank before tipping unit for main-
tenance. Clean muffler area of all grass,
dirt, and debris,
Do not touch hot muffler or cylinder fins as
contact may cause burns.
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SF-SJ, Se-
lect the oil's SAE viscosity grade accord-
ing to your expected temperature.
NOTE: Although multi-viscosity oils
(5W-30, 10W-30, etc,) improve starting in
cold weather, they will result in increased
oil consumption when used above 32°F
(0°C). Check your engine oil level more
frequently to avoid possible engine dam-
age from running low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the tiller
is not used for 25 hours in one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Add SAE 30 mo-
tor oil or equivalent. Tighten oil filler plug
securely each time you check the oil level.
5_ Refill engine with oil, See "CHECK
ENGINE OIL LEVEL' in the Operation
section of this manual
Oil drain _ " (_
Oil FEllPlug
AIR CLEANER
Service air cleaner cartridge every
twenty-five hours, more often if engine is
used in very dusty conditions,
1. Loosen air cleaner screw.
2. Remove air cleaner cover,
3. Carefully remove air cleaner cartridge°
Be careful, Do not allow dirt or debris
to fall into carburetor,
4. Clean by tapping gently on a flat sur-
face,
NOTE: If very dirty or damaged, replace
cartridge_
5, Clean and replace cover. Tighten
screw securely.
_CAUTION: Petroleum solvents, such
as kerosene, are not to be used to clean
cartridge. They may cause deterioration
of the cartridge. Do not oil cartridge. Do
not use pressurized air to clean or dry
cartridge,
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet AP!
service classification SF-SJ,
• Be sure tiller is on level surface.
• Oil will drain more freely when warm,
• Use a funnel to prevent oil spill on tiller,
and catch oil in a suitable container.
1, Remove drain plug,
2, Tip tiller forward to drain oil.
3, After oil has drained completely,
replace oil drain plug and tighten se-
curely,
4, Remove oil filler plug. Be careful not to
allow dirt to enter the engine,
Cover
Air Cleane
Screw
Atr Cleaner
:lge
14