vitra. CDS Manual De Instrucciones página 25

Troubleshooting
Display Cause
HOT The control system monitors
the switch-on time
(time-controlled) and its max.
temperature. A value has
been exceeded.
E00 M1 – Internal error
E01 M2 – Internal error
E02 M3 – Internal error
E12 M1 – Defect
E13 M2 – Defect
E14 M2 – Defect
E24 M1 – Overcurrent
E25 M2 – Overcurrent
E26 M2 – Overcurrent
E36 M1 – Not connected
E37 M2 – Not connected
E38 M3 – Not connected
E48 Overcurrent of motor group 1
E49 Overcurrent of motor group 2
E55 Motor group 1 – synchronisa-
tion lost
E56 Motor group 2 – synchronisa-
tion lost
E60 Collision detected
Solution
Wait until the control system has cooled down and the "HOT" indicator goes out, after which
the table is ready for operation again.
Unplug power adapter!
Contact your Vitra retail partner.
Unplug power adapter!
Contact your Vitra retail partner.
Max. load exceeded -> remove the load from the table.
If the error persists after this, contact your Vitra authorised trade supplier.
Motor not connected
Check cable / plug connector to the motors and carry out reset.
Max. load exceeded -> remove the load from the table.
Motor position too different, if necessary reduce load on the table
Reinitialise table (RESET)
Remove optional ISP and sensor function cause
EN
25