GB
• Do not attempt to repair the
appliance yourself unless you
have specific training to do so.
Leave any work not listed in
this manual to our Service Cen-
tre.
• Do not intake any moist or wet
material or any liquids.
• Do not use the device in closed
or badly ventilated rooms. Do
not use the device near inflam-
mable liquids or gases. In case
of non-observance of these
directions, danger of fire or ex-
plosion exists.
• Keep the device in a dry loca-
tion and out of reach of chil-
dren.
• Handle the unit with care.
Clean the ventilation slits regu-
larly; keep to the maintenance
instructions.
• Keep all cooling air inlets clear
of dirt.
Electrical safety:
• Make sure that the mains volt-
age is compatible with the in-
formation of the label.
• If operating a power tool in a
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use
of an RCD reduces the risk of
electric shock.
• Check the device and the pow-
er cable with plug for damage
before every use. Avoid bodily
contact with grounded parts
(e.g. metal fences, metal post).
• The coupling of the extension
cord must be protected against
splashed water, it must consist
26
of rubber or be surrounded by
rubber. Employ only extension
cords which are stipulated for
use in the open air and are
marked accordingly. The flex-
ible lead cross-section of the
extension cord must at least
2.5 mm
. Always roll out the
2
cable drum completely before
use. Check the cable for dam-
age.
• Keep the cable away from the
field of action and basically
play it out behind the operator.
• Do not carry the device by the
cable. Do not use the cable
to pull out the plug from the
plug socket. Protect the cable
against heat, oil and sharp
edges.
• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifica-
tions, must not be employed.
Remove the plug immediately
from the plug socket in case of
damage to the mains cable.
Do not touch the mains power
supply cable under any cir-
cumstances until you have
pulled the plug out of the mains
socket.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the appliance if the
on/off switch does not work
properly. Always have a dam-
aged switch repaired by our
Service Centre.