Swash Special Mode Operations - brondell Swash CL825-EW El Manual Del Propietario

OPERATING THE SWASH (cont.)
USING THE SWASH (cont.)
Auxiliary Controls
1. Power button – Turns the product On/Off. Press and hold the button for at least 2 seconds
to turn off the Swash.
Note: if the Power button is pressed while front or rear cleansing is operating, the
cleansing function will stop.
2. Rear Cleansing – Selects the rear cleansing function.
3. Nozzle Cleaning – To better clean the nozzles, press this button, the nozzle will extend fully
for easy cleaning. Refer to Maintenance section for additional nozzle cleaning information.

SWASH SPECIAL MODE OPERATIONS

Swash Eco Mode
Swash goes into Eco Mode when the Seat Sensor is not activated and no buttons on Remote
have been active for approximately 10 minutes. The seat heater will automatically set itself to
the "Low" temperature setting to reduce power consumption. Once Eco Mode is activated,
the Eco Mode light on the seat will turn blue and the other lights will turn off.
If no buttons on the Remote control are pressed for approximately 5 seconds, the remote
display lights are turned off to conserve remote battery life.
Selecting/Canceling Eco Mode
1. Press and hold down the "Power" and "Rear Cleansing" auxiliary buttons simultaneously for
approximately 5 seconds until all the seat display lights start flashing.
2. Press the "Rear Cleansing" button to Set or Cancel Eco Mode.
a. If Eco Mode indicator light is turned on, this indicates Eco Mode has been set.
b. If Eco Mode indicator light is turned off, this indicates Eco Mode has been canceled.
3. The new setting will automatically be saved within 10 seconds if no other buttons are
pressed.
20