TURBO MODE
The TURBO button is located on the key pad (Figure 1). The amount of suction is significantly
increased when this button is pressed. To return to NORMAL mode, press the TURBO button
again.
FILTER LIFE REMAINING
The exact number of hours and minutes remaining on the ViroSafe® filter (in use) are displayed
on the LCD screen. When the filter's life is consumed, time remaining will indicate that there are
0 hours and 0 minutes remaining. This line will continually flash. When the filter life reaches this
point, a new filter with time remaining should be inserted; however, the suction will still work.
When the unit's main power is turned off or the system is left idle for more than 6 hours, a new
filter or a filter with remaining filter life MUST be inserted into the filter basket to allow the unit's
suction to turn back on.
When the filter's life is exhausted the
LCD screen will flash "REPLACE FILTER. "
FOOTSWITCH
A pneumatic footswitch is provided. To activate the footswitch, simply plug the footswitch tubing
into the jack (
) on the rear panel. The suction can now be switched ON/OFF by depressing the
footswitch.
EZ LINK™ REMOTE ACTIVATION DEVICE (EZLINK01)
For directions on using the EZ Link™, see instructions accompanying the EXLINK01.
CIRCUIT FUSES
Two 10 amp circuit fuses (8 amp for International systems) are located on the rear panel within
the power entry module. These circuit fuses protect both the system and the operator from dam-
age or injury.
SERVICE
When a service message appears, please contact Buffalo Filter Customer Service for instructions.
Below are some examples of service screens that may appear.
Buffalo Filter Turbo Auto-Sense™ Operator's Manual: Page 11