Buffalo filter LaparoVue Instrucciones De Uso

BUFFALO FILTER
LaparoVue
®
Laparoscopic Solutions
Visibility System
VueTip Trocar Swabs
®
Microfiber Cloth
LaparoVue Setup
®
1. Detach scope cradle from main unit.
Activate LaparoVue
2. Pull slip sheet to activate. LED lights inside ports will illuminate indicating unit has
been activated and warming of cleaning/defogging solution has started.
Puncture Cleaning/Defogging Port
3. Prior to start of surgery puncture cleaning/defogging port on top of the unit with the
VueTip Trocar Swab handle. CAUTION: Do not use scope to puncture port.
®
Scope Insertion
4. Once activated, scope can be immediately inserted to begin warming.
5. Push scope firmly into the warming/white balancing port located on the front of the unit.
Warming
6. Leave scope in warming/white balancing port for a minimum of five minutes for
initial warming. If scope is left in warming port for an extended period of time,
please reduce light intensity to reduce heat. For scopes with limited heating
requirements, reduce warming time accordingly.
7. For additional scope protection rest the scope on scope cradle. Note: Be sure to arrange
stand so that scope is located on a stable surface if left unattended.
White Balancing
8. The scope can be white balanced while it is warming. White balancing procedure is
dependent on the type of camera system utilized. If camera light intensity is too high,
white balancing may fail. Pull scope slightly away from target or reduce the camera's
light intensity. If necessary, white balance with Microfiber Cloth. We recommend NOT
using gauze.
Indications For Use: LaparoVue
device to be used prior to and during endoscopic and
laparoscopic procedures to prevent fogging of the scope lens.
This document is designed to assist in using this product. It is
not a reference to surgical technique.
Unit
®
is a single-use, sterile
®
Scope Cleaning/Defogging Port
Microfiber Surface
Scope Warming/White Balancing Port
Scope Cradle
EN