Feature Guide; Control Panel - GBC FOTON 30 Manual Del Usaurio

FEATURE GUIDE

A. GETTING TO KNOW YOUR LAMINATOR:
(Shown in image A above)
a) FEED TRAY & SIDE GUIDES:
i) Place document(s) to be laminated and use the
side guides to minimise skew. Flip out extension for
larger documents.
b) FEEDER/FEEDER DOOR:
i) Feeds document into laminator. A red light on the
door will indicate that a mis-feed has occurred. Open
the door to clear any mis-feeds.
c) LAMINATOR DOOR:
i) Door that gives access to the inner parts of the
laminator: rollers, film cartridge, etc.
ii) To Open: pull on the silver latch, and lift up
iii) To Close: gently lower using the silver latch,
and push latch closed. DO NOT push down on the
laminator door to close.
d) FILM CARTRIDGE:
i) Replace the film cartridge when empty or when
a different thickness is required. See CARTRIDGE
FILM LOADING for details.
e) LAMINATORS ROLLERS:
i) Rollers heat-up to activate the adhesive on the film
and apply the pressure to ensure the film sticks to the
document.
f) AUTO TRIMMER:
i) When in Auto Cut modes, the trimmer finds the
leading and trailing edge of the document and cuts
the film. In Manual Cut mode, it will cut the film when
the CUT button is pressed.
B. CONTROL PANEL:
(Shown in image B above)
BUTTONS
a) POWER – turns the machine on/off. After 15 minutes
of no use, the machine will automatically turn off.
b) RUN/STOP – used to start and stop the laminator.
i) Dual Function – Manual Advance: Continuously
hold the button to manually advance the laminator
rollers. This can be used to clear jams and debris for
cleaning.
c) MODE – allows users to toggle through three modes
of operation.
i) Auto Feed / Auto Cut – best for standard paper
sizes printed on 80-120gsm paper.
ii) Manual Feed / Auto Cut – best for standard paper
sizes on heavy paper stocks that won't Auto Feed.
iii) Manual Feed / Manual Cut – best for odd shaped
and non- rectangular documents.
d) CUT – pressing this button will cycle the trimmer to
cut the film one time. This button is primarily used in
Manual Cut mode.
INDICATORS
e) STATUS – communicates the status of the machine:
i) Solid Green = ready to use
ii) Green Blinking Sequence = running
iii) Solid Amber = warming up
iv) Amber Blinking Sequence = warming up and
RUN command accepted. Will begin laminating once
ready.
v) Solid Red = error status
f) FILM – LED light will indicate when film is low (approx.
30% remaining) or is empty.
i) Low = Amber LED light
ii) Empty = Red LED light
g) MODE – green LED light identifies what mode of
operation the machine is in.
h) ERROR MESSAGE – communicates error messages
that need to be resolved.
i) DOOR: one or both doors are open
ii) JAM: the machine may encounter two types of
jams:
1. Laminator jam: push and hold the RUN button
to manually advance the rollers to clear itself.
2. Feeder jam: open the feeder door and remove
the paper.
iii) CUTTER: trimmer cannot complete full cut cycle
iv) MANUAL FEED INDICATOR – communicates
when the machine is ready by illuminating GREEN to
feed the next manually fed document. Located on the
Feeder Door.
C. FILM CARTRIDGE:
(Shown in image C above)
a) CARTRIDGE – inserts into the laminator.
b) CARTRIDGE LABEL – indicates film thickness.
Located on top of handle.
c) FILM LEADER – the sealed leading edge of the
film. This edge must be placed facing the exit of the
machine.

GB
8