Important Charging Notes - Lincoln PowerLuber 1860 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Models 1860, 1862, 1862E, 1864
PowerLuber Grease Gun (Lithium)
INDICATOR LIGHT OPERATION
NOTE: Battery temperature will increase during
and shortly after use. Batteries may not accept
a full charge if they are charged immediately
after use. Allow the battery pack to cool to
room temperature before charging for best
results.
Vent slots in top and bottom of charger must

Important Charging Notes

1. Longest life and best performance can be
obtained if the battery is charged when the
air temperature is between 65° F and 75° F
(18° - 24° C). DO NOT charge the battery in
an air temperature below +40° F (4.5° C) or
above 105° F (+40.5° C). This is important
and will prevent serious damage to the bat-
tery.
2. The charger and battery may become warm
to the touch while charging. This is a normal
condition, and does not indicate a problem.
3. If the battery does not charge properly:
a. Check current at receptacle by plugging in
a lamp or other appliance.
b. Check to see if the receptacle is con-
nected to a light switch which turns power
off when you turn out the lights.
c. Move charger and battery to a location
where the surrounding air temperature is
approximately 65° F - 75° F (18 - 24° C).
d. If charging problems persist, take the tool,
battery and charger to your local service
center.
Page Number - 10
4. The battery should be recharged when it
fails to produce sufficient power on jobs.
DO NOT CONTINUE to use under these
conditions. Follow the charging procedure.
You may also charge a partially used pack
whenever you desire with no adverse affect
on the battery.
5. Under certain conditions, with the charger
plugged into the power supply, the exposed
charging contacts of the charger can be
shorted by foreign material. Foreign materi-
als of a conductive nature such as, but not
limited to, steel wool, aluminum foil, or any
buildup of metallic particles should be kept
away from charger cavities. Always unplug
the charger from the power supply when
there is no battery in the cavity. Unplug
charger before attempting to clean.
6. Do not freeze or immerse charger in water
or any other liquid.
Don't allow any liquid to get inside charger.
Electric shock may result. To facilitate the
cooling of the battery pack after use, avoid
placing the charger or battery pack in a
warm environment such as a metal shed or
an uninsulated trailer.
1861
Battery
1850 or 1850E
Battery Charger
Figure 8
Form 404264

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Powerluber 1862Powerluber 1862ePowerluber 1864

Tabla de contenido