Long Term Storage Of Your Heater - Dura Heat DFA50 Manual Del Usurario

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Lamp
Thermostat Power/Reset
Control Knob Switch
(DFA80T MODEL ONLY)
DFA50/DFA80T Models
NOTICE : The major electrical components of this heater are protected by a safety fuse mounted to the PCB board.
power source to insure that proper voltage and frequency are being supplied to the heater.
TO STOP HEATER
1. Turn switch to "OFF" and unplug power cord.
TO RESTART HEATER
1. Wait 10 seconds after stopping heater.
2. Repeat steps under to start heater.
PIGGYBACK POWER CORD
WARNING : SHOCK HAZARD!
• Always cover electric outlet when not in use.
• Don't plug and use an appliance more than 120V/60Hz 5A
current in this outlet.

8. LONG TERM STORAGE OF YOUR HEATER

FUEL TANK DRAIN
1. Drain fuel tank through fuel cap opening.
(For DFA50/DFA80T Models Only)
2. Remove fuel drain bolt from rear bottom side of fuel tank using 3/4" socket or adjustable wrench and drain.
(For DFA135C/DFA180CV/DFA220CV Models Only. See Figure 10)
3. Using a small amount of kerosene, swirl and rinse the inside of the tank.
NEVER mix water with the kerosene as it will cause rust inside the tank.
Pour the kerosene out making sure that you remove it all.
IMPORTANT : Do not store kerosene over summer months for use during next heating season.
4. Reinstall fuel cap. Properly dispose of old and dirty fuel. (For DFA50/DFA80T Models Only)
5.
(DFA135C/DFA180CV/DFA220CV Models Only. See Figure 10)
IMPORTANT : Before reinstalling the fuel drain bolt, make sure the seal is on the bolt. If the seal is
6. Store heater in dry well ventilated area. Make sure storage place is free of dust and corrosive fumes.
7. Store the heater in the original box with the original packing material and keep the USER'S MANUAL
with the heater.
Room Temp. Display
Lamp
Thermostat
Power/Reset
Control Knob
Switch
DFA135C/180CV/220CV Models
Figure 8. Controls for All Models
Using old fuel could damage heater.
not used the bolt cannot be installed correctly and the fuel tank will leak.
Figure 10. Drain Bolt
BTU Control Switch
Fan Guard
DFA80T/DFA135C/DFA180CV/DFA220CV
Figure 9. Piggyback Power Cord
3/4" socket or adjustable wrench.
Seal
Fuel Drain Bolt
9
BTU Control Switch
Push to"HIGH" Push to"HIGH"
Push to"LOW" Push to"LOW"
Cover
Models only
Relief Valve Relief Valve
Outlet