Assemble The Freezer Drawer; Making Minor Adjustments Between Doors; Adjusting The Level - Samsung RF261B Serie Manual De Usuario

ASSEMBLE THE FREEZER
DRAWER
To reattach the drawer after you have moved
the fridge to its fi nal location, assemble the parts in
reverse order.

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can
make fi nal adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, it will not be
possible to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into a notch
on the left control lever, and turn it counter
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)
fl at-blade screwdriver(-) Control Lever
Both control levers must be touching the
fl oor to avoid possible personal injury or
CAUTION
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is diffi cult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
10_ setting up
MAKING MINOR ADJUSTMENTS
BETWEEN DOORS
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
The left door is fi xed. To make minor
adjustments between doors, adjust only
the right door.
1. Pull out the freezer drawer
see the lower hinge
2. Insert a philips screwdriver (+)
of the lower hinge.
4
3. Adjust the height by turning a philips
screwdriver (+)
3
counterclockwise (
When you turn a philips screwdriver (+)
counterclockwise (
move up.
1
Adjustment
part
Fixed part
,then you can
1
.
2
into the shaft
3
clockwise ( ) or
DOWN
).
UP
), the door will
UP
2
4
3 3