Picture Of Control Set Connection; Gyro Adjustment - Carson BLUSTER 250 SE Manual De Instrucciones

c. Picture of Control Set Connection
Assemling gyro:
Make sure all the radio control system components and servos
are in right and easy working condition, and the servo arms are
in the right position.
Fix the gyro to the right place close to the center of gravity.
Plug the connector of the gyro to plug-in 4 and the second one
for the sensitivity (only one cable) to plug-in 5.
Switch on the transmitter and center the trim of the tail rotor.
Connect the flying battery with the controller and wait untill the
LED of the gyro is on. Now the gyro is initialising and it is not
allowed to move the helcopter. After ca. 10 seconds the gyro is
ready and the process of adjustment completed. Otherwise you
need to check the connections over again.
d. Gyro Adjustment
Gyro signal connect to
receiver plug-in 4
Gyro gain connect to
receiver plug-in 5
Reverse switch
Gain adjust Rudder itinery
adjustment
CARSON 3D Helicopter Bluster 250se 50 050 7028
6. Pitch
5. Gyro gain
4. Tail rotor servo
3. Throttle up + down
2. Nick
1. Roll
To set the reverse switch of the gyro:
Turn the helicopter head to the left, if the servo's movement on
the tail pipe is the same as the servo's when turning the rudder
joystick right, that means the direction is ok. Otherwise you
need to turn the reverse switch to the other end.
Gain adjustment:
With the first test of the helicopter, after take off, notice the tail
pipe. Is there any deflexion or is the tail of the helicopter not
calm, you have to reduce the gain till you get a good result.
Connect to tail servo
Indicator LED
GB
11