Important; Expanding Your System; Connec Ng Addi Onal Door Sensors; Connec Ng Pir Mo On Detectors - Tiiwee X1 Manual De Usario

Deac va ng the system
X1 siren: short press the SET bu on.
Remote control: press the Deac va on bu on.
Deac va ng the system will be confirmed by two beeps.
Choosing doorbell-sound or siren sound
In deac vated mode, short press the On/Off bu on on the X1 siren or the
S-bu on on the remote control to switch between doorbell-sounds and siren
sound. The order of the sounds is
1. loud doorbell
2. mild doorbell
3. very loud siren (120dB)
You hear a short fragment of the selected no fica on sound or alarm sound
each me you press the bu on.
IMPORTANT: Changes to the X1 siren se ngs can only be performed when the
X1 is in deac vated mode. If you try to make changes to the X1 while the system
is in the ac vated mode, you will hear three beeps. As a general rule, three
beeps always means that the X1 is not able to process the input. Consult your
instruc ons for use in such case.
When the siren alarm sounds
When a sensor triggers an alarm in siren mode, the alarm sounds for 2 minutes.
Then, the siren stops and the X1 siren returns into ac vated mode again
automa cally. The siren can also be stopped at any me with the remote control.
During an alarm, the LED of the respec ve zone lights up un l the alarm is
switched off.
Stopping an alarm
There are two ways to stop the alarm when the siren sounds. Stop the siren by
short pressing the Deac va on bu on on the remote control.
Alterna vely, you can also stop the alarm on the X1 alarm unit by the following
bu on combina on: Press 3 mes quickly on On/Off bu on followed
immediately by a quick press of the SET bu on.
6

Expanding your system

Expand the X1 system with Tiiwee door sensors and mo on detectors from the
Tiiwee Home Alarm System. It is possible to add up to 10 Sensors per zone. Up
to 10 remote controls can be connected. Furthermore, addi onal X1 siren units,
as well as A3 outdoor sirens, can be connected by combining the exis ng sensors
to the new sirens.
Warranty
Please only use accessories from the Tiiwee Home Alarm System to ensure a
proper func on of the system.

Connec ng addi onal door sensors

This is an example of connec ng a door sensor to zone 2:
De-ac vate the X1 siren by pressing the SET bu on on the X1 or the
■
Deac va on bu on on the remote control.
Press the SET bu on for 5 seconds. You will hear a beep and all four LEDs
■
light up.
Press the SET bu on short two mes to select zone 2. The LED of zone 2
■
lights up.
Ac vate the door sensor by moving the magnet away from the sensor.
■
You will hear two beeps, and the LED of zone 2 will blink twice.
Save the se ng by pressing the On/Off bu on briefly.
■
The door sensor is now connected to zone 2.

Connec ng PIR mo on detectors

Proceed as described with the door sensors in the previous chapter. However,
triggering the device is done by moving your hand in front of the mo on
detector. When performing the pairing procedure, make sure the mo on
detector is facing away from you to avoid unwanted signals from the device
while pairing it to the X1 Siren.

Connec ng remote controls

Up to 10 remote controls can be connected to the X1 siren.
7