Pairing remote controls
Press the SET bu on for 5 seconds. You will hear a beep and all four LEDs
■
light up
Press one (any) bu on on the remote control(s) which you wish to
■
connect. You will hear two beeps for confirma on of correct pairing.
Press the On/Off bu on shortly to store the se ngs
■
The remote control is now connected to the X1 siren.
Adding addi onal sirens to your system
The system can be also expanded with other X1 sirens and A3 outdoor sirens. If
you want to add a siren, all your sensors and remote controls need to be paired
to the new siren. A new siren operates independently from exis ng siren.
Please refer to the below image which outlines the principle.
8
Dele ng accessories or changing the zones
Dele ng sensors or changing the zone for a door sensor
Changing the zone for a sensor
In this procedure, all sensors from a zone are deleted and reconnected to the new z
one(s).
Below is an example for dele ng the door sensor from zone 3 and connec ng
this door sensor to zone 1:
Dele ng zone informa on
o
Deac vate the X1 siren by pressing the Deac va on bu on on the X1 or the
remote control.
o
Elimina ng all sensors from zone 3:
Press the SET bu on for 5 seconds. You will hear a beep and all four LEDs
■
light up.
Press the SET bu on short three mes to select zone 3. The LED of zone 3
■
lights up.
Press the SET bu on for 5 seconds. This will delete all sensors from zone
■
3. You will hear four beeps to confirm, and the LED will blink four mes.
Now, connect the door sensor to zone 1:
Press the SET bu on for 5 seconds. You will hear a beep and all four LEDs
■
light up.
Press the SET bu on short 1 me to select zone 1. The LED of zone 1
■
lights up.
Ac vate the door sensor by removing the magnet away from the sensor.
■
You will hear two beeps, and the LED of zone 1 will blink twice.
Save the se ng by pressing the On/Off bu on briefly.
■
The door sensor has now been removed from zone 3 and reconnected
to zone 1.
9