JENN-AIR JER8885 Guía De Uso Y Cuidado página 29

M
AINTENANCE
Warming Drawer
• NEVER store plastic, paper products or flammable materi-
als in this drawer. The drawer may become too warm for
these items when the oven is in use or the warming drawer
is preheated.
• To avoid contact with the warming drawer heating element,
pull drawer all the way out to add or remove food.
• Never use oven cleaners to clean the warming drawer.
To remove warming drawer:
1. Empty drawer and pull out until it is fully open.
2. Locate the black triangle lever on each side of the drawer.
3. Press the lever down on the right side and lift the lever up on
the left side at the same time. Then pull drawer out another
inch.
4. Carefully pull the drawer all the way out holding on to the
sides, not the drawer front.
8113P417-60B 29
CAUTION
To replace warming drawer:
1. Pull the bearing glides to the front of the chassis glide. (See
picture below.)
2. Align the glide on each side of the drawer with the glide slots
on the range.
3. Push the drawer into the range until levers "click" (approxi-
mately 2"). Pull the drawer open again to seat bearing glides
into position. If you do not hear the levers "click" or the
bearing glides do not feel seated, remove the drawer and
repeat steps 1 through 3. This will minimize possible damage
to the bearing glides.
CHASSIS
GLIDE
BEARING
GLIDE
28
9/28/04, 11:40 AM