Using Your Humidifier - Honeywell HEV680 Serie Manual De Instrucciones

PREPARING THE WICKING FILTER
Step 2
Step 1
1. Remove Water Tanks and lay aside. Grip housing and lift up to expose Wicking Filter.
2. Carry Wicking Filter and Base to sink or tub.
3. Remove Filter from Base and run under cool water until saturated.
4. Carefully place wet Filter back in base; do not squeeze out excess water.
FILLING/REFILLING WATER TANKS
The Tanks can be filled in two ways.
To fill without removing Water Tanks:
Step 1 Step 2
1. Flip Tank Cover open.
2. Pour cool tap water into Water Tank through the Tank Cover opening.
Do not use warm or hot water.
3. Close Tank Cover to keep objects and debris out of water.
Repeat for second Water Tank.
To fill at the sink or tub by removing Water Tanks:
Step 1 Step 2
1. Flip Tank Cover open. Grasp Tank Handle and lift Water Tank to remove from Base. Carry
Tank to sink or tub. NOTE: Do not use the Tank Cover to carry Water Tank.
2. Fill Tank through the Tank Cover opening. When filling, allow enough space at the top to
minimize splashing when carrying. Use cool tap water; Do not use warm or hot water.
NOTE: Do not attempt to unscrew Plunger Housing from underside of Tank.
This is not meant to be removed.
4
Step 3 Step 4
$
Step 3
$
Step 4
Step 3
$
FILLING/REFILLING WATER TANKS
3. Carry Water Tank back to humidifier using two hands; one hand on Tank Handle at the top
of the Tank and other hand supporting the bottom of the Tank. Take care not to push the
Plunger on the bottom of the Water Tank or leaking may occur.
4. Place the Water Tank on the humidifier Base. Close Tank Cover. You may hear the water
draining into the Reservoir.
Repeat with second Water Tank.

USING YOUR HUMIDIFIER

Step 2
Step 1
Power Control
1. With Power Knob in the OFF position, plug humidifier into a polarized 120V outlet.
CAUTION: To avoid electric shock, do not plug humidifier into outlet with wet hands.
2. Turn the Power/Output knob to desired fan setting.
High ( ): Fast humidifying
Medium ( ): Everyday moisture control
Low ( ): Quiet setting
Humidity Control
3. Turn the Humidity Level Knob to the highest setting and run for at least an hour or until a
comfortable humidity level is reached.
4. Then turn the Humidity Level Knob to the left until the green Humidity Reached Indicator
light turns on ( ) and the humidifier turns off. This is your desired humidity level. Now
that your desired humidity level is set, the humidifier will automatically turn back on when
your room drops below this comfort setting and will automatically turn off again when the
comfort setting is reached.
NOTE: For continuous operation, set to high (
Water Tanks
5. When both Water Tanks are empty, the humidifier will automatically shut off and the orange
Refill Indicator ( ) will light up. Turn off the humidifier and refill the Tanks. See Filling/
Refilling Water Tanks on previous page.
NOTE: If the humidifier will not be used for more than a few days, empty the water from the
Water Tanks and Water Reservoir and dry out the Filter to prevent growth of bacteria or mold.
Step 3 Step 4 Step 5
).
(Continued)
5