Network Cable Tracking; Sending Audio Frequency Signal; Tracking Network Cable; Telephone Line Modes Testing - C-LOGIC 3400 Manual De Instrucciones

2.4 Network Cable Tracking

WARNING
TO AVOID ELECTRICAL SHOCK AND INJURY, DO
NOT CONNECT RECEIVER TO ANY AC SIGNAL
LARGER THEN 24V.

2.4.1 Sending Audio Frequency Signal:

Connect both leads("RJ45" Adaptor、 "BNC"Adaptor、
"RJ11" Adaptor、 the red lead and back lead) on the
transmitter to the network cable (or connect the red lead
to target cable and black lead to ground depends on the
circuit). Turn the transmitter switch to "TONE" mode and
the indicator will lights up. Press and hold receiver power
button, move the receiver close to the target network to
receive signal. Adjust receiver volume through sensitivity
switch.

2.4.2 Tracking Network Cable

Use "TONE" mode on transmitter along with the
receiver to track cable. Connect the wire adaptor to
the target network (or connect the red lead to target
cable and black lead to ground depends on the circuit).
Switch to "TONE" mode on the transmitter, "TONE"
indicator turns on. Press and hold the power button
on the receiver. Move the receiver near the target
network to receive audio frequency signal. The tester
detects the direction and continuity of the network cable.
Adjust receiver volume through sensitivity switch.
13

2.5 Telephone Line Modes Testing

2.5.1 Differentiate TIP or RING wire:

Turn the switch on the transmitter to "OFF", connect
the corresponding wire adaptor to the open telephone
lines in the network. If,
a) "CONT" indicator turns green, the red lead on the
transmitter connects to RING of the telephone line.
b) "CONT" indicator turns red, the red lead on the
transmitter connects to TIP of the telephone line.
2.5.2 Determine Idle, Vibrate or in use (off-hook):
Turn the switch on the transmitter to "OFF" mode.
When the target telephone line is at work, connect the
red lead to RING line and the black lead to TIP line, If,
a) "CONT" indicator turns green, the telephone line
is idle.
b) "CONT" indicator stays off, the telephone line is
off-hook.
c) "CONT" indicator turns green along with periodic
red flash, the telephone line is in vibrate mode.
d) When connect receiver antenna to an explored
telephone wire, press and hold the receiver power
button to receive the audio signal.
14