Programming; Programming Keypad - Alliance Laundry Systems SF35PV Manual Del Usaurio

Programming Keypad

All sixteen keys are used in the Programming Mode.
Specific functions are printed in red on the keys. The
Programming Mode is active only when the Program
Mode switch is in the PROGRAM position. (When
programming is complete, remember to return the
mode switch to the RUN position and remove the key.)
Keys 1-6 and the Auxiliary/No Reverse key are dual
Red Keys
Cold Cold is pressed when the step requires cold water.
Low Low is pressed for low-level fill.
Hot is pressed when the step requires hot water.
Hot
Med./Fill is pressed to select medium water level.
Med./Fill
Fill is pressed in the Manual Mode to operate fill valves.
Warm Warm is pressed when the step requires warm water.
High High is pressed for high-level fill.
Erase Cycle Erase Cycle and a two-digit cycle code number are pressed to erase a cycle from memory.
Wash Wash is pressed when the step is a wash or dilution rinse. Then key 1, 2, 3, 4, 6, or 7 is pressed to
choose the type of agitation.
Heat Heat is pressed when auxiliary heat is needed. This must be followed by a specific temperature
selection, such as 165°F. The temperature must be entered; then a time assigned to reach that
temperature must be entered.
Supply Supply is pressed when soap, bleach, or other chemicals are desired. Key 1, 2, 3, 4, or 5 must then be
pressed to indicate the specific supply dispenser being used. Combinations of these supplies can be
programmed. Refer to Programming a Supply Step.
Over Over is pressed when an overflow of water is desired. The drain is closed and water is added without
regard to level. Water flows out the overflow connection for the time assigned to the step.
Add Cycle Add Cycle is pressed to begin the process of programming a new cycle into memory.
Soak Soak is used when no agitation is desired. This follows a fill and/or supply step. The time must be
assigned in hours and minutes. (Wash 3 also provides no agitation.)
Medium Speed Medium Speed is pressed when a medium spin only is desired for washing delicate items not suited
for high-speed spin or when an intermediate spin is desired.
High Speed High Speed is pressed when a fast spin is desired. Pressing the High Speed key once will activate the
H1 spin; twice, the H2 spin; and three times, the H3 spin.
Edit Cycle Edit Cycle is pressed followed by a two-digit cycle code number to display the steps of a
preprogrammed cycle. The cycle may be altered during the edit cycle procedure by deleting, changing,
or adding steps.
Add Step Add Step is pressed to add a step to an existing cycle during the edit cycle procedure.
Clear (black on Clear is pressed when an error has been made in programming a step. Instead of pressing Enter as the
red background) step is completed, press Clear to eliminate the incorrect information. (Clear should never be pressed
when displaying a cycle unless a particular step is to be eliminated or changed. Refer to Displaying a
Cycle in Memory.
F232059

Programming

Programming Keypad
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
function keys in the Program Mode. In each instance
(with the exception of the Warm/High key), when a
key is first pressed in a programming step, the word
printed at the top of the key applies. In most instances,
the next time the same key is pressed – or if another
key has been pressed in the interim – the word printed
on the bottom of the key applies.
Description
31