Programming A Drain Step; Programming A Spin Step; Programming An Auxiliary Step - Alliance Laundry Systems SF35PV Manual Del Usaurio

Programming

Programming a Drain Step

1. The computer must be in the Program Mode, and
the cycle programming sequence must be ready
for the next step.
2. Press the Drain key. The display will read
"D-nncc".
3. Press key 1 for a regular drain to sewer or a floor
drain. The display will read "D1nncc".
4. Press the Enter key. The display will read
"M---S". Now assign the time which will allow
the machine to drain to empty.
This is an alarm time. The machine should drain
in 30 seconds under normal conditions. The
recommended drain time is one minute. Drain
times of more than one minute are not
recommended.
5. Press the Enter key and go to the next step in the
cycle.

Programming a Spin Step

1. The computer must be in the Program Mode, and
the cycle programming sequence must be ready
for the next step.
2. Press the Medium Speed or High Speed key. The
High Speed key must be pressed once for high
speed spin No. 1, twice for high speed spin No. 2,
and three times for high speed spin No. 3. The
display will read "MSnncc" for medium speed or
"H1nncc" for high speed spin No. 1, "H2nncc"
for high speed spin No. 2, or "H3nncc" for high
speed spin No. 3. (If the High Speed key is
pressed when the display shows "H3nncc", the
computer will then return to "H1nncc".)
3. Press the Enter key. The display will read
"M---S". Now assign time in minutes and
seconds to the spin step.
4. Press the Enter key: the display will read
"SDLY" for one second. The display will then
change to "0M-00S".
50
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5. Now assign the time for the spin delay (coast
down). A minimum of 30 seconds is
recommended to reduce belt wear.
A spin delay is always advisable after a
high-speed spin No. 1, No. 2, or No. 3 unless
sequential high-speed spins are programmed in
ascending order. In that case program a spin
delay after the final spin in the sequence.
Also, always program a spin delay after a high
speed spin if another (non-spin) step is to follow.
NOTE: Do not program a Wash 1 step for a
shakeout after the spin step. If such a step is
programmed, the computer will revert to the
previous wash step and will fill with water
accordingly. Refer to Stop Routine. However, a
Wash 1, 2, or 3 step, programmed for ONE second
will select Stop routine agitation and avoid refilling.

Programming an Auxiliary Step

Auxiliary No. 1 and Auxiliary No. 2 may be used to
control an external buzzer or other device (not
supplied with the machine) with a maximum current
draw of less than 1/2 amp, if the machine is not
prompted for wet cleaning.
Auxiliary No. 3 is identified on the fuse board as A3
(signal) and controls the built-in buzzer (alarm)
mounted on the inside wall of the control module.
When A3 is programmed, the signal will sound
continuously for the duration of time assigned. The
same signal (buzzer) is used by the computer for an
alarm condition, such as a "FILL" or "EMTY" alarm.
When the signal is activated by the computer to
indicate an alarm condition, the tone will be pulsating
rather than continuous.
1. The computer must be in the Program Mode, and
the cycle programming sequence must be ready
for the next step.
F232059