Maintenance - GE JGB760DEF2BB Manual Del Propietário

(D
0
C
¢-
(1.)
c-
Z
d
Z
m
Z
Z
Maintenance
Oven Light Replacement
i i sHOcK OR BURN HAZARD: Bef°re replacing °yen light bulb' disc°nnect the electrical
WARNING
power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in
electric shock or burn.
[A CAUTION
I URN HAZARD: The glass cover and bulb should be removed when cool. Touching hot
glass with bare hands or a damp cloth can cause burns.
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
Before replacing the bulb, disconnect electrical power to
the oven at the main fuse or circuit breaker panel. Let
the bulb cool completely before removing it. For your
safety do not touch a hot bulb with a damp cloth. If you
do the bulb may break.
To remove:
Turn the glass cover counterclockwise 1/4 turn until the
tabs of the glass cover clear the grooves of the socket.
Remove the bulb.
To replace:
Put in a new 40-watt appliance bulb. Place the tabs of
the glass cover into the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
NOTE:
[] A 40-watt appliance bulb
is smaller than a standard
40-watt household bulb.
i
[] Reconnect electrical power
i
to the oven once the new :>
bulb is installed.
[]
For improved lighting inside
the oven, clean the glass
cover frequently using a
wet cloth. This should be
done when the oven is
completely cool.
31_"
Max
length
Bulb
(;lass cover
Lift-Off Oven Door
The door is very heavy, Be careful when removing and lifting the door, Do not lift door by the handle,
To Remove the Door:
1. Fully open the door.
2. Pull the hinge locks up and away from the range
frame to the unlocked position.
3. Firmly grasp both sides of the door near the top.
4. Close door until the top of the door is approximately
6" from the range frame.
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
1. Firmly grasp both sides of the door near the top.
2. With the door at the same angle as the removal
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
3. Fully open the door. If the door will not fully open, the
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
4. Push the hinge locks toward the range cavity and
down to the locked position.
5. Close the oven door.
Pull hinge locks up to unlock
Bottom
edge of
slot
X
Hinge arm
Rest notch on bottom edge
of hinge slot
Removal position
Push hinge locks down to lock
8 49 85211 4