Work Light - Ecco 10 Serie Instrucciones De Operación

Ocultar thumbs Ver también para 10 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Work Light

The Work Light is an adjustable halogen light which is mounted in the upper level of the 20 or 30 Series
Lightbar.
Bulb Replacement
!
WARNING!
Halogen bulbs are extremely hot! Allow to cool completely before attempting to remove. Gloves and eye protection should be
worn when handling halogen lamps as they are pressurized and accidental breakage can result in flying glass.
Consider changing all of a specific bulb type when one burns out. This will minimize removal and replacement of outer lenses.
H3 Bulb:
1. See "Lens Removal" for instructions on removing and replacing lenses.
2. Using a #2 point Phillips screwdriver, remove the 2 screws from both sides of the work light. Remove the black
retaining cover. The internal reflector will become loose.
3. From the rear of the internal reflector, remove the bulb retaining screw. Note: Separate the bulb wire spade
connector.
4. Replace with equivalent bulb. Do not touch the glass with bare hands.
5. Reverse steps 1, 2, and 3 to re-assemble the work light.
6. Power up and test the system before replacing the lenses.
Safety Director
The Safety Director System is used to provide traffic directions from the rear of the vehicle, using a number
of sequenced patterns controlled from a remote keypad. The system is available in 12V or 24V Halogen
or LED versions and can be installed in the lower level of 10, 15, 20 and 30 Series Lightbars. The Safety
Director controls 5, 6, 7 or 8 light-heads, depending on the length of the lightbar and the number of other
lower level components. A manual is supplied with each keypad detailing the operation and configuration
options if required.
The Safety Director can also be used as an auxiliary warning system with flash patterns selected using
either the keypad or hard-wired input wires.
The Safety Director is designed to be maintenance free with the exception of lighthead bulb replacement.
For bulb replacement, refer to the "Halogen Flashers" section.
920-0052-00 Rev. F
Page 13 of 17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

15 serie20 serie30 serie

Tabla de contenido