General Recommendations - IMS Welding POWERDUCTION 37LG Manual De Instrucciones

Translation of the original instructions
10. To top up the cooling liquid, refer to the installation instructions.
It is recommended to change the cooling liquid every year, otherwise you may damage the POWERDUCTION's lance.
Prefer the use of the special welding coolant offered with Powerduction (see § Maintenance).
«PURGE» MODE (39LG & 37LG)
This mode is only available if the heat is not activated (green switch is off).
1. Place the inductor, making sure it points upwards. Place the cable on the floor to avoid liquid spillage.
2. Unscrew the accessory using key 27 supplied with the machine (39LG) ou l'inducteur (37LG).
3. Place the torch button above a bucket with a capacity of 10l minimum.
4. To empty the tank, place the product button above a bucket with a capacity of 10l minimum :
- 39LG : unscrew the «purge» button.
- 37LG : lean the product on the back.
39 LG
It is recommended to change the cooling liquid every two years, otherwise you may damage the Powerduction's lance.
COOLING CIRCUIT AND «FORCED COOLING» MODE
To prevent the cooling liquid's temperature from rising, the cooling fan starts, in any event, when the liquid's tempera-
ture reaches 35°C (95°F). As soon as the temperature goes below that, the cooling fan switches off.
During long periods of use, the POWERDUCTION has a forced cooling mode. To activate it :
1. Set the main switch (1) to ON.
The machine initialises in 2 seconds.
2. Press the activation button (2) as described on page 5. The indicator on button (2) and the lance support LED (12) both
switch on, indicating that the machine is ready to operate.
3. Hold (>3 seconds) the button (10). The « Forced cooling» mode is activated.
The cooling fan then starts automatically. The cooling fan will be audible and the «Fan ON» message will appear on the
display.
To stop the «Forced cooling», press the activation button to stop the heating or hold the button (10) again. The message
«Fan OFF» is displayed.
MAINTENANCE

General recommendations

• It is recommended to change the cooling liquid every two years, otherwise you may damage the Powerduction's lance.
• Prefer the use of the special welding coolant offered with Powerduction. Do not use automotive fluids, only coolants
with low electrical conductivity.
• Prefer the use of the special welding coolant offered with Powerduction. Do not use automotive fluids, only coolants
with low electrical conductivity.
• It is essential that the maintenance of the product is performed by qualified, authorised staff, that is fully aware of the
recommendations outlined in this manual.
POWERDUCTION 37LG / 39LG / 50LG
37 LG
EN
31