How The Cycle Works; Setting The Controls - Kenmore SELECT CLEAN 665.75822 Guía Para El Uso Y Cuidado

HOW THE CYCLE WORKS

The SELECT CLEAN™ Self-Cleaning cycle uses
temperatures much hotter than normal oven use to
break up and burn away soil and grease. SELECT
CLEAN will set the clean time automatically, once
you choose the soil level. You can choose SoilL
(light soil), SoilA (average soil) or SoilH (heavy soil).
SoilL will clean for approximately 2-2
for 3-3 1 ⁄ hours and SoilH for 4-4
2

SETTING THE CONTROLS

To start Self-Cleaning immediately:
1.
Press SELECT CLEAN.
Press pad twice, SoilA (for average soil) will
replace SoilL.
Press pad three times, SoilH (for heavy soil) will
replace SoilA.
NOTE: You can scroll through all 3 settings
(SoilL, SoilA and SoilH) continuously by pressing
SELECT CLEAN.
2.
Press START/ENTER.
3.
After the SELECT CLEAN Self-Cleaning cycle ends:
LOCKED goes off and the door unlocks.
4.
Press any pad to remove "End" and bring back
time of day; or open door, at which time "door"
will be displayed. Then close door and time of
day will appear in display window.
USING THE SELECT CLEAN™ SELF-CLEANING CYCLE
1 ⁄ hours, SoilA
2
1 ⁄ hours.
2
The door must be closed completely for it to lock and
the cycle to begin. If properly closed, the door will
lock approximately 6 seconds after START/ENTER is
pressed. The cycle time includes an approximate 30
minute cool down time. To see the time of day during
the cycle, press CLOCK for 5 seconds.
PRESS YOU SEE
SELECT
CLEAN
(example shows light soil
setting)
PRESS YOU SEE
HEAT
YOU SEE
YOU SEE
(when pressing any pad)
YOU SEE
(when opening the door)
continued on next page
CLEAN
ON
LOCKED CLEAN
CLEAN
27