Dri-Eaz Dri-Pod F451 Manual Para El Usuario

Dri-Pod™ Direct Flow Carpet Dryer
The Dri-Pod is a high velocity airmover that creates an aggressive 360°airflow
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING! To reduce the risk of fire or electric shock, do not
use this fan with any solid-state speed control device.
WARNING! Unit must be grounded. Do not use with an
extension cord. Connect only to an outlet provided with a ground
fault interrupting device.
WARNING! Never operate a unit with a damaged power cord, as
this may lead to electrical or fire hazards. If power cord is
damaged, it must be replaced by a cord of the same type and
amperage rating.
WARNING! Do not touch grills when unit is operating.
NOTICE: Keep motor dry. For indoor use only.
NOTICE: Unplug when not in use or when moving unit.
NOTICE: Do not allow children to play with or around the unit.
Be sure the unit is inaccessible to children when not attended.
NOTICE: Always operate the unit on a stable, level surface so it
cannot fall and cause injury.
WARNING! Do not alter or modify your Dri-Pod in any way. Use
only replacement parts authorized by Dri-Eaz Products, Inc.
Modifications or use of unapproved parts could create a hazard
and will void your warranty. Contact your authorized Dri-Eaz or
Sapphire distributor for assistance.
OPERATING INSTRUCTIONS
1. Unwrap the cord and plug the unit into a standard 115V
outlet. CAUTION: Be sure switch is in the off position before
connecting unit to power outlet.
2. Position the Dri-Pod in the center of an area to be dried.
Switch on. The Dri-Pod can dry an area approximately
10 × 10 ft. (3 × 3 m).
3. When surface is dry to the touch, switch unit off and
reposition the unit in the next section to be dried.
4. When finished, unplug the unit and re-wrap the cord in the
cord wrap.
07-01759C 2012-08 Warranty 07-01760
Owner's Manual
Model F451
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA 98233
Phone: 800-932-3030 Fax: 360-757-7950 www.dri-eaz.com
across floor surfaces to accelerate drying.
Patents: http://www.LBpatents.com
Transporting and Storing
Always use the handle to load or carry the unit. Units may be
stacked for transport and storage.
When transporting in a vehicle, secure the unit carefully to
prevent sliding and damage to the unit and/or injury to vehicle
occupants.
PARTS IDENTIFICATION
Handle
Cord wrap
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the Dri-Eaz
Service Department at 800-932-3030
SPECIFICATIONS
Model F451
Weight 10.6 lbs. | 4.8 kg
Dimensions 15.2 × 15.2 × 8.9 in.
(D × W × H) 38.5 × 38.5 × 22.5 cm
Amp draw 1.1 amps
Control On/Off switch
Power 130W/115V
Cord length 10 ft. | 3 m
Fan 5 blades
Construction Injection molded housing, wire grill
Safety UL listed and CSA standards
Specifications are subject to change without notice. Some values
may be approximate.
1
On/off switch
Dri-Eaz Products, Inc.