Dri-Eaz Dri-Pod F451 Manual Para El Usuario

Dri-Pod™ Direct Flow Carpet Dryer
The Dri-Pod is a high velocity airmover that creates an aggressive 360°airflow
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING! To reduce the risk of fire or electric
shock, do not use this fan with any solid-state
speed control device.
WARNING! Unit must be grounded. Do not use with an extension cord.
Connect only to an outlet provided with a ground fault interrupting device.
WARNING! Do not touch grills when unit is operating.
NOTICE: Keep motor dry. For indoor use only.
NOTICE: Unplug when not in use or when moving unit.
NOTICE: Do not allow children to play with or around the unit. Be sure
the unit is inaccessible to children when not attended.
NOTICE: Always operate the unit on a stable, level surface so it cannot
fall and cause injury.
WARNING! Do not alter or modify your Dri-Pod in any way. Use only
replacement parts authorized by Dri-Eaz Products, Inc. Modifications or
use of unapproved parts could create a hazard and will void your
warranty. Contact your authorized Dri-Eaz distributor for assistance.
WARNING!
a) Do not operate any fan with a damaged cord or plug. Discard fan or
return to an authorized service facility for examination and/or repair.
b) Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be
tripped over.
OPERATING INSTRUCTIONS
1. Unwrap the cord and plug the unit into a standard 115V outlet.
CAUTION: Be sure switch is in the off position before connecting
unit to power outlet.
2. Position the Dri-Pod in the center of an area to be dried. Switch on.
The Dri-Pod can dry an area approximately 10 × 10 ft. (3 × 3 m).
3. When surface is dry to the touch, switch unit off and reposition the
unit in the next section to be dried.
4. When finished, unplug the unit and re-wrap the cord in the cord
wrap.
Transporting and Storing
Always use the handle to load or carry the unit. Units may be stacked for
transport and storage.
When transporting in a vehicle, secure the unit carefully to prevent
sliding and damage to the unit and/or injury to vehicle occupants.
FOR SERVICE CALL YOUR LOCAL DISTRIBUTOR or the Dri-Eaz Service
Department at 800-932-3030
07-01759E F451 (115V)
Owner's Manual
Model F451 (115V)
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA 98233
Phone: 800-932-3030 Fax: 360-757-7950 www.dri-eaz.com
across floor surfaces to accelerate drying.
Patents: http://www.LBpatents.com
PARTS IDENTIFICATION
Handle
Cord wrap
WARNING: This product may expose you to chemicals,
including lead and phthalates, known to the State of
California to cause cancer, birth defects, or other
reproductive harm. For more information, go to
P65Warnings.ca.gov
SPECIFICATIONS
Model F451
Weight 10.6 lbs. | 4.8 kg
Dimensions 15.2 × 15.2 × 8.9 in.
(D × W × H) 38.5 × 38.5 × 22.5 cm
Amp draw 1.1 amps
Control On/Off switch
Power 130W/115V
Cord length 10 ft. | 3 m
Fan 5 blades
Construction Injection molded housing, wire grill
Safety UL listed and CSA standards
Specifications are subject to change without notice. Some values
may be approximate.
1
On/Off switch
Dri-Eaz Products, Inc.