Starting And Stopping - Troy-Bilt TB6044 XP Manual Del Operador

WARNING:
Operate this unit only in a well-ventilated
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
position when pulling the starter rope (Fig. 11).
STARTING INSTRUCTIONS
1. Check the oil level. Refer to Checking the Oil Level.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON ( I ) position at all times (Fig. 8).
3. In cold weather only (below 50° F): Move the cold weather
start lever to the Closed position (Fig. 10).
4. Slowly press and release the primer bulb 10 times (Fig. 9).
5. Crouch in the starting position (Fig. 11).
6. DO NOT squeeze the throttle control (Fig. 8). Pull the starter
rope with a controlled and steady motion until the unit starts
(Fig. 11).
7. DO NOT squeeze the throttle control. Allow the engine to warm
up for 30 seconds.
8. If it was moved in step 3, move the cold weather start lever back
to the Open position (Fig. 10).
9. Press the throttle lockout and squeeze the throttle control (Fig. 8).
Continue warming the engine for an additional 30 to 60 seconds.
The unit may be used during this time.
IF... the engine does not start, begin the starting procedure with step 4.
IF... the engine stops while the throttle control is squeezed, begin
the starting procedure with step 5.
IF THE ENGINE IS HOT... begin the starting procedure with step 4.
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 8).

STARTING AND STOPPING

Off (O) / Stop
Starter Rope Grip
10
On ( I ) / Start
Throttle Lockout
Throttle Control
Fig. 8
Primer Bulb
Fig. 9
Open Closed
Fig. 10
Fig. 11
Cold Weather
Start Lever
Starting
Position