Data Copying; Tv Program And Audio Selection - Alcad 912-TP Serie Manual De Instrucciones

34 - ENG
the
Output channel B/G CCIR S
S band channels. Press the C/S key to switch between standard channels
and S band channels.
When
Frequency
output frequency with a resolution of ±0,25 MHz.
The language transmission is made altogether with the TP output channel
transmission.
To change standards, select
to choose the desired standard. Press
continue programming the module.
To move to channel or frequency mode, press
The letters
or freq.
frequency mode.
programming the module.
WARNING, receivers are adjusted ex works to channel S-41. We
recommend using a previous planning of output channels or output
frequency and a further noting down in the receiver box before
programming, thus avoiding the selection of already engaged channels.
Make sure that the output channels or output frequency are not being used
in the distribution. Nevertheless, to verify the output channel or output
frequency programmed in the TP receivers that are not properly noted
down, use the READ function.
6.

DATA COPYING

The COPY function is provided, to avoid transmitting the TP module data
one by one. Aiming at the transmodulator, press the F and COPY keys. The
PS programmer must be kept aimed at the receiver until the
message is deleted from the screen. The programming led will blink while
transmitting and all the data, except the output channel and the OSD
language will be sent.
7.

TV PROGRAM AND AUDIO SELECTION

Once transponder data are transmitted, the transmodulator will show the
following message TUNING TRANSPONDER... After tuning the transponder
it will show SEARCHING LIST... message, showing the TV programme and
audio list of the transponder.
By selecting
Programs List
keys, you will be able to move through the program list shown on the OSD.
Installation and programming manual
is displayed on the screen, you could select the
Standard
and
Press to confirm your choice and to continue
is displayed you could select
. The letters
to confirm your choice and to
allow you to select output in channel or
on the PS Programmer, using
and allow you
and select
Channel
Copy...
and