Gewiss CHORUS GW 16 972CB Manual De Programación página 44

If the temperature sensor connected to the auxiliary input 2is not working properly, its contribution is
excluded from the calculation of the measured temperature (which then depends exclusively on the value
measured by the device sensor).
If the floor temperature sensor is not working properly, the temperature alarm is activated immediately (it
stops when the floor sensor resumes its normal operation). In the case of a temperature alarm, the icon
flashes.
If the automatic day and time update function is enabled, the device will synchronise itself with the remote
server at regular intervals, and the parameter for setting the day of the week will not be visible in the
standard menu.
USER INSTRUCTIONS
To confirm the set value, press the
seconds; expiry of the time-out (30 seconds) or pressing the push-
button result in exiting the change page without saving it.
Floor alarm threshold temperature setting
Press the button key to access value change; after the access,
the current parameter value is displayed. Use the circular touch slider
or the push-button
threshold for the auxiliary sensor (value can be set from 15.0 °C to
100 °C). The parameter is displayed below if the function of the
auxiliary input 2 (P 35) is "measurement of the floor temperature with
sensor GW10800". To confirm the set value, press the
key within thirty seconds; expiry of the time-out (30 seconds) or
pressing the push-button
saving it.
Automatic day and time update
Press the button key to access value change; after the access,
the current parameter value is displayed. Activate/deactivate the
automatic day and time update function (0 = disabled; 1 = enabled)
via the circular touch slider or the
set value, press the button key
the time-out (30 seconds) or pressing the push-button
exiting the change page without saving it.
44
button key within thirty
to change the floor temperature alarm
result in exiting the change page without
push-button. To confirm the
within thirty seconds; expiry of
button
result in