Powering The Scale - Health O Meter Professional 596KL Manual Del Usuario

POWERING THE SCALE

Powering the Scale – Inserting Batteries
1. Remove the battery compartment
cover located on the side of the display
by sliding it downward in the direction
of the arrow.
2. Remove the battery housing from the
display by pushing down the notch
under the battery compartment.
3. Replace or install 6 new AA batteries.
®
Health o meter Professional
recommends using an alkaline or
lithium battery, rated for 130°F (54°C)
operation. Do not use zinc-carbon
batteries.
4. Re-install the battery housing into the
display. Ensure that the battery
housing pins are inserted facing the
inside of the display.
5. Replace the battery compartment
cover.
Note: This scale will always default to the settings and units last used (LB or KG).
Note: If "Lo" appears on the display, it indicates that the battery power is low. It does NOT
indicate a problem with the weight measurement.
Warning: If the scale will not be used for some time, remove the batteries to avoid a
safety hazard. Disposal of batteries must be performed in accordance with the prevailing
national, regional or local regulations that apply to
Powering the Scale – AC Adapter (not applicable to 596KL-C)
1. Connect the AC adapter into the adapter jack on the scale's display.
Warning: To avoid a safety hazard, use only the AC adapter
provided with the scale.
2. Plug the scale's AC adapter into the power source/wall outlet.
3. When the AC adapter is disconnected from the scale, the scale will
switch to battery power if batteries are installed.
Caution: Always plug the AC adapter into the scale first, then into the power source/wall outlet.
P/N UM596KL_596KL-C REV20190923_web
Display
you.
8
Battery
compartment
cover